Macard Wifi Extender Blinking Blue Light: What You Need To Know?
The Macard wifi extenders are modern networking devices with advanced features. These are widely accepted by users for faster network coverage and seamless connectivity. Similarly, like other networking devices, it also has LED indicators that blink in different colors. Sometimes users experience issues with the Macard wifi extender blinking blue light when it stays for longer than usual.
Commonly, the normal behavior of the flashing blue light on your networking device appears when it tries to connect to the master router’s network. In short, it generally blinks when the connection is in progress. But if you experience a Macard wifi extender flashing blue light as an issue, then read this post to understand it in detail.
Why is the Macard wifi extender blinking blue light continuously? How to fix it?
As you know a blue LED flashes when the connection is in progress with the primary router. But if it stays for longer than normal timings, then it may be an issue. So, to understand the causes behind the blue light issue on the Macard repeater and fixes for it, you must walk through this section.
Reasons for persistent blue light
- Poor signal strength
- Unstable network
- Signal interferences
- The extender is out of the router’s range
- Technical errors
- Outdated firmware
Quick Fixes to resolve Macard wifi extender flashing blue light
After you become aware of the reasons that cause the flashing blue light on the Macard extender for longer. It is time to resolve these issues by following the given fix-outs:
Remove signal obstructions
When there are signal interferences present, then must eliminate them. These are mirrors, furniture, microwaves, cordless phones, etc. Therefore, it is important to remove them otherwise, relocate your repeater.
Stabilize the network
When you face issues with the wireless network, then must use an ethernet cable to stabilize it. Also, place your range extender in a central location and ensure strong signal strength. If network issues persist, then you must contact your ISP authority.
Place the repeater within the router’s network range
In addition, if your extender is located out of the router’s range or far away from this, then the Macard wifi extender blinking blue light problem occurs. So, it is recommended to place the repeater within the router’s network range or in the same room where the master router is positioned.
Reboot the Macard extender
If your extender is working slowly or has continued flashing blue LED on it, then this may happen because of technical errors. Therefore, power cycle it. To do so, power off and unplug the repeater, router, and modem for 30 seconds. Afterward, plug it back and check if the problem gets solved.
Upgrade the Macard repeater firmware
Generally, users forget to check the networking device’s firmware. So, when the extender runs on the outdated firmware file, then it shows network disconnectivity and blue light issues. Hence, upgrade the software if prompted by entering its web interface.
How to factory reset Macard extender?
When none of the above-mentioned methods work to resolve the blue light on Macard extender, then hard reset it. To perform such an action, follow the steps mentioned below:
- Firstly, locate the WPS button on the range extender.
- It is found on the side or at the back of the repeater.
- Now, press and hold this knob for 15-30 seconds using a paperclip/pinpoint.
- After that, release it and the networking device gets back to its default settings.
- At last, you need to reconfigure it from scratch or connect with us for more info.
Final Words
In essence, this brief post outlines the necessary information regarding the Macard wifi extender blinking blue light. Additionally, you explore here the normal blue LED behavior and when it should be considered an issue. Also, possible causes and fixes are presented to you. Hope you find this guide beneficial to get rid of such issues!