Macard WiFi Extender Not Working: Quick Troubleshooting Guide
Is your Macard WiFi Extender Not Working as expected? You are not alone! Yet, this is one of the common issues due to the poor wifi signals, technical glitches, etc. Apart from this, you may see no signal, abnormal LED behavior, or any other issue that can give rise to the errors in setup.
Consequently, this guide will let you understand the Macard WiFi Extender Setup Not Working issue comprehensively. Moreover, we will also suggest some expert tips to resolve this issue immediately. So, stay focused here!
Common Reasons Your Macard WiFi Extender Not Working
To effectively troubleshoot the Macard WiFi Extender Not Working issue, it is essential to understand it first. Knowing this issue is paramount to uncovering the primary causes behind its malfunctioning. Sometimes, issues occur due to setup errors, making the entire device idle. So, here are the key factors leading to this issue:
- Poor internet/WiFi signals
- Incorrect credentials
- Firmware failure or an outdated firmware file
- Incorrect network settings
- Improper extender placement
- Loose cable connection
- Power supply issues/fluctuations, etc.
Most importantly, you must connect your router and the extender to eradicate the Macard WiFi Extender Setup Not Working issue. Both issues are correlated and are the cause and effect of each other. If your setup is not working properly, your router will not work normally. So, find some practical solutions to fix this issue instantly.
How to Fix the Macard WiFi Extender Not Working
Indeed, it is frustrating seeing the Macard wi-fi extender not working. Nevertheless, you have identified the common reasons behind this persistent issue, and knowing the fixes is vital to bring it back online. Here are the simple troubleshooting steps you can try to fix the Macard WiFi Extender Not Working:
- First, ensure that the Macard extender is attached to your wifi router correctly.
- You can also check that the indicator lights on the wifi extender are with the appropriate lights.
- Then, restart your modem, primary router, and the Macard extender by disconnecting & reconnecting them after 30 seconds.
- Most importantly, make sure that your extender is set in a perfect position, in close vicinity to your primary Wi-Fi router.
- Also, make sure that your primary Wi-Fi connection is good and secure cable connections.
- In addition, ensure that the SSID and password entries and login credentials are correct.
- Further, one may consider reducing the interferences by relocating other electronic devices farther than the extender.
Macard WiFi Extender Setup Not Working
Sometimes, the frequent challenge is seen in the setup failure. In case your Macard WiFi Extender is not working in configuration, these steps will assist you in resolving the problem.
- To begin with, verify that your extender is operating at the 2.4 GHz frequency band.
- After that, simply connect to the default Wi-Fi network of the extender.
- If the Macard setup page is not loading, restart your browser or switch to another one.
- Otherwise, you can re-attempt the setup with the WPS button of your extender and main router.
- Certainly, you must check the default IP address of your range booster.
- Then visit the Macard website and verify whether there are any available firmware upgrades and updates.
- Finally, carry out a factory reset on your extender by holding down its pinhole button for 5-10 seconds. This brings your device to its original settings.
On the Whole
In short, understanding and resolving the Macard WiFi Extender Not Working issue is not overwhelming. Even such annoying connectivity problems are manageable, provided you follow the right instructions. Also, your network configuration should always be the basis of your interactions on the Internet. Hopefully, you have now learned the quick fixes to the Macard WiFi Extender Setup Not Working issue and have it running again.